Global Settings
Last updated
Last updated
Global settings can be opened from the Project List screen immediately after opening the app. Select the to open the settings.
The Aircraft Settings are only accessible when Astro is connected to Site Scan. If the option is grayed out, connect to the Herelink hotspot.
Sets the configuration for how the stick inputs control the aircraft. This option is set to mode 2 by default. Unless you are very familiar with other control modes, we highly recommend that you avoid changing this setting.
Shows the current calibration state of the sensors in the aircraft. If all options are green, no action is needed. If a sensor is not calibrated properly, the dot will be yellow or red. Tap on the associated sensor to recalibrate.
It is recommended to do Sensor Calibrations in the AMC app. Please refer to https://docs.auterion.com/hardware-integration/flight-controller-customization/sensors-setup/compass-calibration
The Camera Settings are only accessible when Astro is connected to Site Scan. If the option is grayed out, connect to the Herelink hotspot.
