You can determine if Astro needs an update by following steps 2-4 below. The current firmware number available will be on the Software Release Notes page.
Download the firmware file from the Astro Support page or the Suite.
Connect Astro to your computer with a USB cable.
Power on aircraft with one battery and wait about 15 seconds for aircraft to fully boot.
Using a browser such as Chrome or Safari, open the aircraft's info/update page at http://10.41.1.1 (internet connection is not needed).
In the Update Auterion OS box, click Browse, and select the firmware file downloaded above.
Click Update. (Should take about 10 minutes.)
After the update completion message, verify that the webpage shows a "Release name" that matches the downloaded file and that all the motor LEDs are on.
If the aircraft gives an error message, power cycle the aircraft and try again.
Connect Astro to your computer with a USB cable.
Power on aircraft with one battery and wait about 15 seconds for aircraft to fully boot.
Using a browser such as Chrome or Safari, open the aircraft's info/update page at http://10.41.1.1 or astro.local/ (internet connection is not needed).
Please do not format Herelink to factory settings! All of Freefly's configurations to make Herelink work optimally with Astro out of the box will be lost. If you are experiencing issues with Herelink, please reach out to us at contact@freeflysystems.com for assistance.
Connect your Herelink to the internet through WiFi.
Swipe down from the top of the screen to pull down the Android quick menu.
If there are any updates available, you will see them here. Follow the instructions to get your software updated. Alternatively, go to Android Settings > About phone > System Updates.
If you get a "Can't check for updates" message, go to Settings > Date & Time, and ensure the date is correct. If not, manually correct it before trying to update the software again. 40% battery is required to update the Herelink firmware.
To find the Herelink firmware version, drag down from the top of the Herelink's touch screen and tap the settings gear in the top-right corner. Scroll all the way to the bottom of this menu and select About phone. On the next screen, look for the OEM build number.
Open AMC and activate Advanced mode
Connect AMC to Astro
Select: Vehicle setup > Parameters > Tools > Reset to vehicle's configuration defaults.
Reboot Vehicle
Calibrate sensors as required
