Note: If you are installing a different FPV Transmitter other than the Freefly FPV system, please see the appendix section for wiring guidance.
1.
Connect the FPV camera cable to the FPV extension located inside the chassis at the base of boom.
2.
Screw the FPV mount to the top of the chassis with the (x4) M3x14 screws and washers.
3.
Screw the FPV camera bracket to the FPV mount with (x2) M2.5x5 screws and washers.
4.
Screw the FPV camera to the bracket using the included (x4) M2x4 screws and washers.
5.
Plug the FPV cable into the back of the camera.
1.
Connect the VTX cable to the VTX extension located inside the chassis at the base of boom #3
2.
Screw the VTX and its mount to the interior of the closeout panel adjacent to the base of boom #3 using 2x M3x10 screws. Then plug in the VTX cable. This can be done without removing the closeout panel.
3.
Route the SMA mount and cable through the access port at the base of boom #3. Ensure you do not unplug the u.FL connector during this step.
4.
Screw the SMA mount to the accessory mounting pattern using 2x M3x5 screws
5.
Attach the included TBS Triumph Antenna to the SMA jack and tighten.
