Pilot Pro Public
  • Intro
  • Getting Started
  • Operating Handbook
    • User Interface
    • Ecosystem
      • RTK
    • Power and Charging
    • Radio Modules
      • Herelink Radio
      • Doodle Labs Radio Module
        • Doodle Pro Tips
        • Doodle Channel Selection
        • Doodle RJ45 Ethernet Port
        • Doodle Binding / Pairing
    • Input Output Mapping
      • Advanced Input Mapping
  • Maintenance
    • Troubleshooting
    • Software and Firmware Updates
      • Software Release Notes
  • Specs
    • Technical Specs
    • Radio Technical Specs
    • Testing and Certification
    • Compliance
  • Interfaces
    • Electrical Interfaces
    • Mechanical Interfaces
    • Software Interfaces
Powered by GitBook
On this page
Export as PDF
  1. Interfaces

Electrical Interfaces

PreviousInterfacesNextMechanical Interfaces

Last updated 1 year ago

Connector
Information / Pinout

1: USB C Charge Input

USB C PD Supports up to 100W input No Data

2: Molex External Power Input and CAN

2 - Power In

3 - CAN High

4 - CAN Low Mating Connector: Molex 0430250400

3 and 4: JST GH 6-pin

5: Micro SD Slot

Recommended: SanDisk Ultra microSD or faster

6 and 7: USB C 3.0 Data and Power Out

USB type C Connector 5Gbps SuperSpeed 5V at 1.5A power output per port

5-26V up to 100W input (12V-26V recommended for powering while in use or fast charging) 1 - GND

1 - GND 2 - 5V (1A) Output 3 - UART TX (output from Pilot Pro) 4 - UART RX (input to Pilot Pro) 5 - GPIO 6 - GPIO Mating Connector: JST GHR-06V-S