12mm Rails Kit

Installation Instructions

1. Flip your aircraft to access the underside of the chassis

2. Set it on a clean, flat horizontal surface to avoid damaging props if they are installed

3. Using the 4x included M3x10 'Combohead' screws and hex ball driver, loosely fasten each of the two rail adapters to the lower chassis, taking note of the position of the GPS unit to determine forward flight direction.

   1. Refer to the lower chassis mounting pattern guide. This accessory mounts to the 'green' 160mm square pattern.

   2. The adapters can be mounted either parallel or perpendicular to the direction of flight, depending on your application. Most applications align with forward flight direction.

   3. The adapters can also be mounted angled inwards or outwards, depending on which suits your specific application best

      
4. Open the red locking levers and innsert the two 12mm x 500mm rails to the desired position within the clamps.

   1. Note that while the adapters are not tightened down, the tubes will be able to bring the adapter bores into alignment.

   
5. Proceed to tighten the red locking levers and then tighten the 4x chassis fasteners fully.

6. Flip aircraft right-side-up and proceed to attach your payload and landing gear solution.