Protips, Limitations, and Troubleshooting
First things first
The OGI Payload is supported in Astro firmware version 1.9.1 or later. Update your Astro!
Make sure to update the Pilot Pro controller to the latest version, too!
When powered on, the Ventus OGI may take about 10 minutes to cool down and calibrate. If you power off for only a short time, the calibration time is reduced. You do not have to wait for the cooldown to be completed before taking the flight.
#Protips
Slow speed mode makes the gimbal easier to control when zooming in.
Learn about it under the Precise Gimbal Control section
Be careful not to become disoriented when flying with the camera zoomed in. We recommend resetting the camera zoom to 1x before flying to a new inspection location.
Limitations
Gimbal
Do not hot-swap or plug in the gimbal when the aircraft is powered on. This can damage the aircraft or gimbal.
Make sure you are using the correct vibration isolator
More details can be found in the isolator section
Troubleshooting
Gimbal tilt controls are reversed
You can invert the gimbal tilt control under the camera settings
Last updated