After Every Flight

	Item	Action
1.	Mode Switch	MANUAL
2.	Home Switch	OFF
3.	ALTA Pro	LAND
4.	Motors	DISARM and STOP
5.	Orientation Lights	VERIFY FLASHING GREEN
6.	Status LED	VERIFY SLOW FLASHING WHITE
7.	ALTA Pro QGroundControl	CHECK for warnings
8.	Batteries	DISCONNECT AND REMOVE
9.	Radio Controller Power	AS REQUIRED
10.	Aircraft Condition	INSPECT
11.	Motor and Prop Condition	INSPECT
12.	Battery Condition	INSPECT

When not using the Autoland feature, make sure to switch to Manual Mode prior to landing.

	Users may land in Manual Mode, Altitude Mode, or letting the ALTA Pro land autonomously when doing a waypoints mission. Quickly reverting to manual mode when landing in Altitude mode will prevent ALTA Pro unwanted movements .

Upon landing, disarm the motors by holding minimum throttle and full left yaw. This is typically done on the left radio control stick by moving it to the bottom left corner with mode 2 controllers. Disarming can only be done while in Manual Mode. Once the motors are stopped and disarmed, the Orientations Lights will flash green, and the Status Light will slowly flash white, indicating it is safe to approach ALTA Pro.

	Only approach ALTA Pro after confirming that it is disarmed by verifying the Status Light and Orientation Light colors.

The downwash from the propellers can disturb debris. This debris can be ingested by the propellers or motors and cause damage. After the flight, ensure there is no damage to the propeller blades and that the motors still spin freely and quietly. Take extra care when operating in areas with large amounts of debris, such as in sand, dirt, or gravel.

After flight is also a good time to check the condition of battery packs. Always refer to the battery manufacturer’s recommendations for inspection and replacement intervals or requirements.